Description
WD-40 Specialist® Contact Cleaner, featuring patented Smart Straw technology, blasts away oil, dirt, flux reside
and condensation from sensitive electronics and electrical equipment with pinpoint precision.
It dries quickly, leave no residue and removes over 95% of common surface contaminants, making it the best at
cleaning electrical contacts and for optimal performance of equipment.
Safe and ideal for use on printed circuit boards, controls, battery terminals, switches, precision instruments and electric panels.
**Always check with the manufacturer before performing maintenance on devices. Test Lab: Sterling Laboratories (Toledo, OH); ASTM D4488; Test date 8/2018
APPLICATIONS FEATURES & BENEFITS
• Printed Circuit Boards • Cleans Sensitive Electronic Equipment
• Controls • Switches • Leaves No Residue
• Tape Heads • Plastic & Metal Safe
• Precision Instruments • Dielectric Strength > 25,000 Volts
• 50-state VOC Compliant
• Quick Drying
• NSF K2 Reg# 146857
Physical & Chemical Properties :
BOILING POINT (INITIAL): 152-180°F
DENSITY: 0.71
SOLUBILITY IN WATER: Partially soluble
pH: Not Applicable
VAPOR PRESSURE: 153 mmHg @ 25°C (n-hexane)
VAPOR DENSITY: > 2 (air=1)
PERCENT VOLATILE: 100% VOC: 45%
COEFFICIENT OF WATER/OIL DISTRIBUTION: Not Determined
APPEARANCE/ODOR: Clear liquid/hydrocarbon odor
FLASHPOINT: <-29.2°F Tag Closed Cup
FLAMMABLE LIMITS: LEL: 1.1% UEL: 17.1%
DIRECTIONS
Shut off all power and allow any hot surfaces to cool.
Make sure all stored power is drained from the system.
Shake Can Well. Flip straw up for pinpoint STREAM or down for wide angle SPRAY.
Hold can 6 to 8 inches away from the surface and spray directly on to the electronic device or circuit board to eliminate
and remove any contaminants that may cause loss of electrical contact.
Tilt surface while cleaning and allow any excess cleaner to run off.
Allow product to dry completely and thoroughly vent the system before restoring power.
Packaging : 1 carton = 24 cans
Price quoted above is for 1 can
Reviews
There are no reviews yet.